Speed 3.5 cc Rules

1. Model : Any model may be used ;

2. Engine: Any engine may be used with capacity from 3,01 to 3,50 cm³;

3. Exhaust Systems: The overall length of the exhaust system must not exceed 240 mm measured from the centre line of the cylinder to the furthest point of the exhaust system. This dimension is to be measured along the centreline of the exhaust. The internal diameter of the exhaust outlet shall not exceed 6.5 mm. Open exhaust is not allowed;

4. Fuel: Standard FAI supplied by the race organization;

5. Lines and controls Lines:  As F2A rules. Length is measured from engine centerline to the handle bar or the vertical axis of the handle.                                                                                                                    The entire control system must be subjected to a tensile test of 250N (25.5 kgf);

6. Propeller: Only thermoplastic 2 blade glass reinforced propellers may be used, which must not be allowed to exceed the manufacturers specified RPM limit.

7. Tender procedure: The competition takes place on three rounds. Piloting by proxy is permitted, in which case the competitor must start and release the model. Pilots and competitors must be in possession of the FAI license valid for the current year. For the classification, the best speed established on the three rounds will be considered;

8. Piloting: Same rules for F2A. Also, it is possible to pilot with only the wrist inserted into the fork or with the handle beside and close to it and gripping the pylon with the other hand. In this last case the vertical axis of the handle never must be behind the axis of the pylon. The detachment of the wrist or to keep the axis of the handle behind the pylon or the interruption of the grip from it for more than a lap during the timed base, involves the cancellation of the fly. However, piloting to the pylon is strongly recommended as per FAI F2A rules;

 

Note

For anything not covered by these regulations, the provisions of the FAI Sporting Code Sez.4

– Vol.F2 cat. F2A